HIKVISION DS-K3G501X Series User Manual

Note
●
The displayed parameters may vary for dierent access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
●
Some of the following parameters are not listed in the Basic Informaon page, click More to
edit the parameters.
Name
Edit the card reader name as desired.
Card
Authencaon Interval
The me interval between two connuous card recognions when authencang.
Repeated Authencaon Interval
Within the specied interval, repeated authencaon of the same card number (uploaded by
dierent devices) is invalid, and only one authencaon is performed.
Enable Failed Aempts Limit of Authencaon/Max. Failed Aempts for Authencaon
Enable to report alarm when the card reading aempts reach the set value.
Card Reader Type/Card Reader Descripon
Get card reader type and descripon. They are read-only.
4.
Click OK.
5.
Oponal: Click Copy to, and then select the card reader(s) to copy the parameters in the page to
the selected card reader(s).
Congure
Parameters for Alarm Output
Aer adding the access control device, if the device links to alarm outputs, you can congure the
parameters.
Before You Start
Add access control device to the client, and make sure the device supports alarm output.
Steps
1.
Click Access Control → Advanced
Funcon → Device Parameter to enter access control
parameter conguraon page.
2.
In the device list on the
le, click to expand the door, select an alarm input and you can edit
the alarm input's parameters on the right.
3.
Set the alarm output parameters.
Name
Edit the card reader name as desired.
Alarm Output
Acve Time
How long the alarm output will last aer triggered.
4.
Click OK.
DS-K3G501X Series Tripod Turnsle
68

HIKVISION DS-K3G501X Series Specifications

General

Brand	HIKVISION
Model	DS-K3G501X Series
Category	Turnstiles
Language	English