HIKVISION DS-KD9203 Series - Door Station Settings; Recognition with Mask Settings; Add Residents Management

Door Staon Sengs
Edit the parameters of the door staon (including but not limited to, community No., building No.,
oor No., room No. and device mode).
Steps
1.
Congure the parameters according to the actual needs.
Note
●
Outer door staon can only edit the Community No., Project No. and No.
●
The No. of the main door staon is 0.
●
The No. of sub door staons should be larger than 0 and ranges from 1 to 8.
●
Each unit should add 1 main door
staon. Up to 8 sub door staons can be added to the main
door
staon.
2.
Oponal: Enable the Normally Open Mode according to your needs.
The door remains open.
3.
Oponal: Select the language.
4.
Aer conguraon, press * to save and exit.
Recognion
with Mask
Steps
1.
Enable Face with Mask
Detecon.
2.
Select the Passing Level of Face Mask Recognion.
3.
Edit the Fce with Mask & Face 1:N Matching Threshold and Fce with Mask & Face 1:N
Matching Threshold (ECO Mode).
6.1.3 Add Residents
User Management
You can add, edit and delete the informaons of the users.
Steps
1.
Hold * and # at the same me to enter the authencaon page.
2.
Authencate via administrator.
-
Authencate face/card/ngerprint to login.
-
Press # to enter the password to login.
3.
Switch to User Management according to the
ps on the page.
4.
Press # to enter the
sengs page.
Video Intercom Face Recognion Door Staon User Manual
18