Video Intercom Master Station·User Manual
36
Figure 4-30 Local Network Parameters
4. Enter the local IP address, subnet mask, gateway address, and port No..
5. Click the Save button to enable the settings.
The default port No. is 8000.
After editing the local network parameters of device, you should add the devices to
the device list again.
Linked Devices Network Configuration
Purpose:
In the linked devices network configuration interface, you can configure the network
parameters of master stations, SIP servers and management centers of the same LAN.
The devices can be linked to the door station and realize the linkage between these
devices.
Steps:
1. Click the Linked Network Configuration button to enter linked network configuration
interface.
Figure 4-31 Linked Network Configuration
2. Enter the SIP server IP address, security control panel IP address and security control
panel port No..
3. Click the Save button to enable the settings.
Advanced Settings
Steps:
1. Click the Advanced Settings button to enter advanced network settings interface.
To Next Page
Loading...
Need help?
General
