Rail Network Video Recorder User Manual
28
2. Check the checkbox of Enable Dialing to enable the 3G dialing function of the device.
3. Select Network Mode as Auto, Adjust, or 3G Only.
Auto: the work mode is set as the detected stronger signal.
Adjust: the work mode is set as the 3G mode, as long as 3G signal is detected, even if it is weak.
3G Only: the network mode is set as 3G mode, that is 2G mode is not available.
4. Optionally, if you have a dedicated dialing network, you can configure the 3G VPDN (Virtual Private Dialup
Network) settings.
1) Click the Set button of More Settings.
2) Input the APN (access point name), Dialing Number, User Name, and Password.
3) Select the Verification Protocol.
4) Click OK to save the settings and exit the interface.
Figure 3. 5 APN
5. Click OK and reboot the device to activate the new settings.
6. You can view the dialing status on the Dialing Status interface (Main Menu > Status > Dial).
3.3 Wi-Fi
Purpose:
You can connect the device to the Wi-Fi networks and transmit the data via the Wi-Fi.
Step:
Enter the Wi-Fi Settings interface.
Main Menu > Basic Settings > WiFi
To Next Page
Loading...
Need help?
General
