HIKVISION DS-TCG405-E - Chapter 3 Capture Configuration; 3.1 Quick Configuration; 3.1.1 Set Basic Parameters; 3.1.2 Adjust Image

Chapter 3 Capture Conguraon
3.1 Quick Conguraon
3.1.1 Set Basic Parameters
When the I/O coils have been laid and the device has been connected to trigger capture in the site,
you can set the basic parameters in quick conguraon to realize capture quickly.
Before You Start
The device
posion has been adjusted.
Steps
1.
Go to Quick Conguraon → Basic Conguraon .
2.
If you need to modify the device IP address, enter IP Address, Subnet Mask, and Default
Gateway.
3.
Select Scene Mode.
3.1.2 Adjust Image
You can adjust the posions of the lane line, lane right limit, and trigger line, and adjust the lens if
the lens is vari-focal lens.
Steps
1.
Go to Quick Conguraon → Image Adjustment .
2.
Adjust lens to meet the license plate with 120 to 180 pixels.
Note
●
There are two ways to measure the license plate pixel. You can click Measure Plate on Real-
Time Picture interface, and draw a frame on the license plate posion to measure the pixel.
Or measure the pixel with the Windows drawing tool.
●
The lens of some models are prime lens. Lens adjustment is not supported. The actual device
prevails.
●
For some models, you need to adjust the focal lens and focus via the lens lever.
Entrance and Exit Capture Camera User Manual
5