HIKVISION DS-TCG405-E - 4.1.2 Control Barrier Gate

4.1.2 Control Barrier Gate
Link the barrier gate to realize the control and management of the vehicles at the entrance or exit.
Steps
1.
Go to Conguraon → Device Conguraon → Entrances and Exits → Entrance and Exit .
Figure 4-2 Control Barrier Gate
2.
Select Control Mode.
By Camera
The barrier gate is controlled via the license plates recognized by the capture camera.
By Plaorm
The barrier gate is controlled via the plaorm which is connected to the capture camera.
Note
Connect the capture camera to the plaorm if you want to control the barrier gate by plaorm.
It is recommended to select this mode.
3.
Enable or disable the funcon of keeping barrier open for following vehicles.
4.
Oponal: Check Lock Barrier Gate for Large-Sized Vehicle.
Entrance and Exit Capture Camera User Manual
19