HIKVISION DS-TCG405-E - Chapter 5 Network Configuration; 5.1 Set IP Address

4.3 Set Serial Port
4.3.1 Set RS-485
Set RS-485 parameters if the device has been connected to a vehicle detector or other RS-485
devices.
Before You Start
The corresponding device has been connected via the RS-485 serial port.
Steps
1.
Go to
Conguraon → Device Conguraon → System Conguraon → Serial Ports .
Figure 4-4 Set RS-485
2.
Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
3.
Select Working Mode.
Applicaon Mode Trigger
Select it if the vehicle detector has been connected via the RS-485 serial port.
Transparent Transmission
Select it, and the network command can be transmied to RS-485 control command via the
RS-485 serial port.
LED Display
Select it when the LED display is connected to the device via RS-485 serial port.
4.
Click Save.
4.3.2 Set RS-232
Set RS-232 parameters if you need to debug the device via RS-232 serial port, or peripheral devices
have been connected.
Before You Start
The corresponding device has been connected via the RS-232 serial port.
Entrance and Exit Capture Camera User Manual
23