HIKVISION DS-TCG405-E - Page 38

Steps
1.
Go to Conguraon → Device Conguraon → System Conguraon → Serial Ports .
2.
Click Advanced Sengs.
Figure 4-5 Set RS-232
3.
Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
4.
Select Working Mode.
Console
Select it when you need to debug the device via RS-232 serial port.
Transparent Channel
Select it, and the network command can be
transmied to RS-232 control command via the
RS-232 serial port.
Narrow Band
Reserved.
5.
Click Save.
Entrance and Exit Capture Camera User Manual
24