Hill-Rom P1441B - The Automatic Contour down Function Does Not Operate

2.12 The Automatic Contour Down Function Does Not Operate
Chapter 2: Troubleshooting Procedures
Page 2 - 22 Hill-Rom® Basic Care™ Bed, Hill-Rom® 305 Manual Bed,
Hill-Rom® 405 Electric Bed Service Manual (MAN336 REV 2)
2.12 The Automatic Contour Down Function Does Not Operate
1. The head section does not lower when the control for the auto contour
down is pressed.
Yes No
↓→Go to step 4.
2. The head function lockout is off.
NOTE:
If the LED for a bed function lockout is on, the function is locked out.
Yes No
↓→Turn the head function lockout off. If this corrects the problem,
go to “Final Actions” on page 2-4.
3. Do the procedure on page 2-8. The head section lowers when the control
for the auto contour down is pressed.
Yes No
↓→Call Hill-Rom Technical Support at 800-445-3720 (USA).
4. The knee section does not lower when the automatic contour down switch
is pressed.
Yes No
↓→Turn the knee function lockout off. If this corrects the problem,
go to “Final Actions” on page 2-4. Otherwise go to step 5.
NOTE:
If the LED for a bed function lockout is on, the function is locked out.
5. Do the procedure on page 2-13. If this corrects the problem, go to “Final
Actions” on page 2-4. Otherwise, call Hill-Rom Technical Support at
800-445-3720 (USA).