Features
26 TotalCare® Bariatric Bed and TotalCare® Bariatric Plus Therapy System
User Manual (143434 REV 8)
Head Angle Alarm
The head angle alarm assists the caregiver in maintaining the
head elevation of 30° or 45°.
The head angle alarm lets the caregiver set an alarm to sound if
the head section goes below 30° or 45°.
To Activate:
1. Raise the head section to the applicable position
above 30° or 45°.
2. Press the Alarms tab on the GCI.
3. Press Modify under the Head Angle Alarm section.
4. Press the desired angle.
If the head section gets below the selected 30° or 45°, an alarm sounds and a message shows on the GCI.
To Clear the Alarm:
• Raise the head section above 30° or 45° to clear the alarm.
or
• Follow the on screen instructions to cancel the alarm.
or
• Silence the alarm by pressing the Alarm Pause control on the siderail opposite the GCI.
NaviCare® System
The NaviCare® System is an enterprise system that connects and monitors Hill-Rom® beds and surfaces. The system
sends bed and surface data to network applications for caregivers to view and receive alerts. For complete operational
instructions for the NaviCare® System, refer to the NaviCare® System User Manual (P0004447).
The system’s Alerts feature is configured from the NaviCare® System application. The application is turned on or off at
the nurses station; however, the Alerts feature can be paused from the bed.
An indicator next to the NaviCare menu item on the GCI shows the status of the Alerts feature.
To Pause the Alerts Feature at the Bed:
1. Press the Alarms tab on the GCI.
2. Press the Pause Alarms button under the NaviCare® Alerts
section.
NOTE:
When the Alerts feature is deactivated from the bed, an indicator will show on
the NaviCare® System application at the nurse’s station.
To Reactivate the Alerts Feature at the Bed:
1. Repeat the above steps.
To Next Page
Loading...
Need help?
General
