English 23
Trouble or fault Possible cause Action to be taken
The tool cannot be pressed
fully against the working sur-
face
The rotating sleeve is not fully
closed.
▶ Close the rotating sleeve.
→ page 12
The nail detector is jammed. ▶ Clean the base plate and
remove all foreign objects.
Take care to ensure adequate
lubrication of the fastener strip
guides with Hilti lubricant spray.
Part of the nail detector is broken. ▶ Check for correct operation of
the nail detector by checking
that the tool is ready for use
→ page 10.
No fasteners loaded in the tool ▶ Load the tool with fasteners.
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
9 Manufacturer’s warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 30.04.2019 | Doc-Nr: PUB / 5491711 / 000 / 00
To Next Page
Loading...
Need help?
General
