Table of Contents System Manual Modular Systems
Page 6 of 114 HI 800 191 E Rev. 2.02
7.7.4 Configure Line Control 82
7.7.4.1 Required Signals 82
7.7.4.2 Configuring Pulsed Outputs 83
7.7.4.3 Configuration Example with ELOP II Factory 83
7.7.5 Generating the Code for the Resource Configuration 84
7.7.6 Configuring the System ID and the Connection Parameters 85
7.7.7 Loading a Resource Configuration after a Reset 85
7.7.8 Loading a Resource Configuration from the PADT 86
7.7.9 Loading a Resource Configuration from the Flash Memory of the Communication
System 87
7.7.10 Deleting a Resource Configuration from the Flash Memory of the Communication
System 87
7.8 Configuring Communication with ELOP II Factory - up to CPU OS V7 88
7.8.1 Configuring the Ethernet Interfaces 88
7.8.2 System Signals of safeethernet Communication 90
7.8.3 Configuring the safeethernet Connection 92
7.8.4 Configuring the Signals for safeethernet Communication 93
7.9 Handling the User Program 95
7.9.1 Setting the Parameters and the Switches 95
7.9.2 Starting the Program from STOP/VALID CONFIGURATION 95
7.9.3 Restarting the Program after Errors 95
7.9.4 Stopping the Program 95
7.9.5 Program Test Mode 95
7.9.6 Online Test 96
8 Operation 97
8.1 Handling 97
8.2 Diagnosis 97
8.2.1 Light-Emitting Diode Indicators 97
8.2.2 Diagnostic History 97
8.2.3 Diagnosis in SILworX- CPU OS V7 and Higher 99
8.2.4 Diagnosis in ELOP II Factory - up to CPU OS V7 99
9 Maintenance 100
9.1 Interferences 100
9.2 Replacing Fans 100
9.3 Loading Operating Systems 100
9.3.1 Loading the Operating System with SILworX 101
9.3.2 Loading the Operating System with ELOP II Factory 101
9.3.3 Switching between ELOP II Factory and SILworX - not with F*03 101
9.3.3.1 Upgrading from ELOP II Factory to SILworX 102
9.3.3.2 Downgrading from SILworX to ELOP II Factory 102
9.4 Repair of Devices and Modules 102
10 Decommissioning 103
11 Transport 104
12 Disposal 105
Appendix 107
Glossary 107
To Next Page
Loading...
