7 Start-Up System Manual Modular Systems
Page 92 of 114 HI 800 191 E Rev. 2.02
Figure 14: Peer-to-Peer Parameters in the Inputs Tab - CPU OS up to V7
4. The system parameters Receive Timeout, Response Time, Connection State and Version
can be evaluated in the user program based on the signal assignment performed in the
Signal Editor.
The status signals can be evaluated in the user program.
To set a system signal from the user program
1. Right-click the resource in the ELOP II Factory Hardware Management and select P2P
Editor on the context menu to open it.
2. Select the row for the required resource.
3. Click the Connect System Signals button. The P2P System Signals window opens. Select
the Outputs tab
Figure 15: Connection Control System Signal in the Outputs Tab - CPU OS up to V7
The user program can set the Connection Control system signal.
7.8.3 Configuring the safeethernet Connection
The following parameters can be set for a resource in the P2P Editor:
1. Profile - see below
2. Response Time
The response time is the time period that elapses until the sender of the message receives
acknowledgement from the recipient.
To Next Page
Loading...
