System Manual Modular Systems 7 Start-Up
HI 800 191 E Rev. 2.02 Page 61 of 114
Loading by performing a reload is possible
With F*03 devices only!
TRUE during the first cycle after a reload, otherwise FALSE
Safety time set for the controller in ms
Start of processor system using PADT is allowed
Start of processor system using PADT is not allowed
ON during the first cycle after starting, otherwise OFF
Bit-coded state of the power supply units.
Compact controllers and remote I/Os:
Undervoltage with 24 V supply voltage
(Low voltage with battery) not used
Low voltage with internally generated 5 V voltage
Low voltage with internally generated 3.3 V voltage
Overvoltage with internally generated 3.3 V voltage
Error with 24 V supply voltage
Error with 5 V voltage of power supply
Error with 3.3 V voltage of power supply
Undervoltage with 5 V voltage
Overvoltage with 5 V voltage
Undervoltage with 3.3 V voltage
Overvoltage with 3.3 V voltage
System ID of the controller, 1...65 535
Revolving millisecond counter (64-bit)
Bit-coded temperature state of the processor system
Temperature threshold 1 exceeded
Temperature threshold 2 exceeded
Remaining Global Force
Duration [ms]
Time in ms until the time limit set for global forcing expires.
Maximum permissible duration of a RUN cycle in ms.
Table 30: Hardware System Variables for Reading the Parameters
To Next Page
Loading...
