82
6.3 Replacing the Battery
1. Disconnect the test leads from the unit and set the
function switch to OFF.
2. Detach the holster from the unit.
3. Using a Philips screwdriver, turn the battery cover screw
to the OPEN position, slide the battery cover to the side,
then lift the battery cover and remove it from the unit.
4. Disconnect the battery from the snap-on battery connec-
tor, and replace the battery with a new one.
Battery type: 6F22 (manganese) or 6LR61 (alkaline)
5. Close the screw on the battery cover, and then reattach
the holster.
When closing the case up, be careful not to pinch the
wires on the snap-on battery connector.
If the battery cover does not fit back into position properly,
make sure that the screw is in the OPEN position.
OFF
(1)
(2)
To Next Page
Loading...
