3.8 Using D/A Output
94
• The rectifier cannot be changed when using the FASt setting (waveform output). (The cursor cannot be
moved.)
• Output of 0 V will be generated for channels without data, if a rectifier is selected, or if a change in the set-
tings causes the measured value to be shown as invalid data [- - - - -].
• Never supply input to an output terminal. Doing so may damage the instrument.
Active power high-speed analog output terminals
The instrument’s Hi-P1, Hi-P2 and Hi-P3 terminals continuously output the active power level in 1-wave
units. These terminals can be used to observe variations in active power that track input.
To Next Page
Loading...
