Hioki SM-8213 - Basic Procedures for a Measurement

23
VOLTAGE SELCTOR switch setting
HV
-
EN shorting plug inserti
on
VOLTAGE SELCTOR switch setting
HV
-
EN shorting plug insertion
Measuring Voltage Setting
Range Setting
Timer Setting
-- (See 6.6.1)
Comparison and Judgment Value Setting
-- (See 6.6.2)
-- See 6.3.
-- See 6.2.
5.5 Basic Procedures for a Measurement
<Preparation>
<Measurement>
<End>
Power ON
VOLTAGE SELCTOR Switch Setting
30-minute warm-up
Calibration
Sample Connection
Control Setting
Preparatory Voltage Charging
Measurement -- See 6.1.
Residual Voltage Discharge
End
Measuring Rods checks