37
Start of
Measurement
End of
Measurement
8. REMOTELY CONTROLLED MEASUREMENT
A measurement can be remotely controlled by shorting the “G” and “+”
terminals of the REMOTE IN of the External Input/Output terminal block on
the rear of the unit. When the terminals are shorted by a remote switch, a
measurement will start, and when opened the measurement is ended.
Fig. 8.1.1 shows an example wiring and the signal timing.
Fig. 8.1.2 shows the external input/output terminal block.
■ Signal Timing
REMOTE IN OFF OFF
ON
Fig. 8.1.2
Fig. 8.1.1
To Next Page
Loading...
