Hirschmann BAT series - Connecting LAN and WLAN Connectors; Bat-F; BAT-Rail

42
Installation BAT
Release 05 03/2013
2.9 Connecting LAN and WLAN connectors
In the “Dual-Band Industrial Access Point / Client / Access Bridge BAT54-
Rail” user manual, you will find further information for connecting the LAN
and WLAN connections with the corresponding remote terminals.
2.9.1 BAT-F
 Connect the access point to your LAN for configuration.
 Assemble the network cable with the M12 plug supplied.
 Plug the network cable into the LAN connector of the device, and into a
free network connection port on your local network (or into a free port on
a hub/switch). Alternatively, you can connect the device to a separate PC.
The port auto-negotiates upon connection; either a straight or a crossover
cable can be used.
2.9.2 BAT-Rail
 Connect the access point to your LAN for configuration.
 Plug the network cable into the LAN connector of the device, and into a
free network connection port on your local network (or into a free port on
a hub/switch). Alternatively, you can connect the device to a separate PC.
The port auto-negotiates upon connection; either a straight or a crossover
cable can be used.