EasyManua.ls Logo

Hisense AHM-080FJFAA - Page 17

Hisense AHM-080FJFAA
65 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11
5.1.3.4 Domestic Hot Water Running
Step 1
Power on, the default state of wire remote
controller will appear, and previously running
function may appear on the LCD screen. According
to the actual mounting (refer to 5.1.7 In-situ
Settings “d3”), press function key to show
domestic hot water ; continuously press function
key to shift the icon between floor heating and
domestic hot water until the domestic hot water is
selected.
Heating
Domestic Hot
Water
Step 2
To increase water tank temperature, press “ġ” of
the temperature setting key ; if it is reduced,
press “Ģ . For domestic hot water, the highest
water outlet set temperature is 75°C, and the
lowest set temperature is 35°C.
Water Tank
Temperature Code
Water Tank Set Temperature
Actual Water
Tank Temperatur
Begin Running
Step 3
, the LED lamp on, and the
machine begins running.
5.1.3.5 Powerful Water Storage Running
Step 1
Before powerful water storage, go to “5.1.7 In-situ
Settings”, set the target temperature for powerful
water storage of water tank (“F6”), and also set the
“Electric Heating of Water Tank” (“d8”) as active.
Step 2
At the standby state, press the hot water key for
3 seconds, and go to powerful water storage.
Domestic Hot Water
Electric Heater of Water Tank
Step 3
After going to powerful water storage, the domestic
hot water and electric heater
is running.
Step 4
After powerful water storage starts, quit from the
powerful water storage under the following 3
conditions
(1) At powerful water storage mode, press the hot
water key for 3 seconds.
(2) When the water tank temperature reaches the
set water temperature for powerful water
storage (5.1.7 In-situ Settings “F6”).
, the machine stops
running.
5.1.3.6 Heat Recovery
Step 1
At the standby state, set “Heat Recovery” function
as active (5.1.7 In-situ Settings “E8=1”) and the
domestic water tank mode active (5.1.7 In-situ
Settings “d3=1”). At the indoor air conditioner
cooling mode, it automatically turns to heat recovery
function.
Domestic Hot
Water
Press key
ON/OFF
at 1 Hz.
This means powerful water storage
(3) Press key
ON/OFF
Heating
flashes at 1 Hz
flashes at 1 Hz

Table of Contents

Related product manuals