15
7-day Timed
Start
5.1.6.2 Schedule Setting
At the shutdown state (it can’t turn to schedule
setting when the machine is on), press the time
schedule key ⑨ for 3 seconds, start or stop the
schedule setting function. At this mode, through
③, cancel, sterilization key ①
, run mode selection
⑦
and function selection ⑥, the timing function at
time periods each day can be realized and also
set the functions and parameters such as water
outlet temperature at each time period.
Step 1
Press the time schedule key
⑨
for 3 seconds, go to
flashes. Through
“ ġ
”, “
Ģ ” of the temperature
control key ③, the day in the week is selected.
Monday
Step 2
Press the time schedule key ⑨, go to the time
period setting state each day. The time period [01]
flashes at 1 Hz. Press “˚”, “˘” of the time setting
key , and selected the time periods to be set, from
time period 1 to 8.
Ԣ
Time Period
Selection
If the time period is not set and only the number of
time periods is flashing, as shown above.
● There are two indication states after time period
is set.
● Type one: timed startup indication.
The time period above is 01. The machine starts at
6:00 in the morning of Monday for floor heating,
the controlled water outlet temperature is 40°C,
and floor heating code is P1.
● Type two: timed shut down indication.
In the Fig above, the time period for timing is 02,
and the machine executes the order of shutdown at
8:30 in the morning of Monday.
Step 3
Press the time schedule key ⑨, and then through
pressing “˚” , “˘” of the time setting key
Ԣ
,
select the timed on (“ ”
flashes at 1 Hz), timed
off
(“ ”
flashes at 1 Hz) and cancel timing
(“ / ” flashes at 1 Hz).
the setting of day in the week, and the icon “ ”
Time Period
Selection
Time Period
Selection
using 8 keys, time schedule key ⑨, “˚” , “˘” of time
setting key
Ԣ, “
ġ” “Ģ ” of temperature control key
To Next Page
Loading...
