EasyManua.ls Logo

Hisense AHM-080FJFAA - Page 3

Hisense AHM-080FJFAA
65 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
se it in this temperature range.
IMPORTANT NOTICE
i
This manual should be considered as a permanent part of the air conditioning equipment and should
remain with the air conditioning equipment.
Temperature
(°C)
The right is therefore reserved to vary specifications without notice.
This air conditioner is designed for several uses only, such as room cooling and heating, and
domestic hot water in water tank.
Do not use this water module for other purposes, such as drying clothes, refrigerating foods, or for
other cooling or heating process.
No part of this manual may be reproduced without written permission.
Install water module in the indoor places, such as basement, balcony, equipment room and water
closet etc.
Do not install water module in following places that easily cause fire, mechanical deformation or failure.
*Where there is splashing oil (including engine oil).
*Where there are sulfurous gases (such as hot spring).
*Where there are flammable gases.
*Coastal places with salts, strong acids and alkali which are corrosive to the module.
*Where there is splashing water.
Pay attention to the following points when the unit is installed in hospital or other facilities where
there are strong electromagnetic waves from medical equipment.
*Do not install the unit where the electromagnetic wave is directly radiated to the electrical box, wiring,
remote controller and adapter.
*At least 3 meters from strong electromagnetic wave radiators, such as radio equipment.
Installation and service must conform to local standards, laws and regulations.
Signal words (DANGER, WARNING and CAUTION) are used to identify levels of hazard seriousness.
Definitions for identifying hazard levels are provided below with their respective signal words.
If you have any questions, contact your dealer or service ce
Water module must be installed indoors and designed for the temperatures in the table below.
Hisense
pursues a policy of continuing improvement in design and performance of products.
Hisense
cannot anticipate every possible circumstance that might involve a potential hazard.
nter of
Hisense
Max.
Min.
Outdoor Unit
10DB
43DB
-25WB
35DB
Water Module
Water Supply
Temperature
5
25
15 55
DB: dry bulb temperature WB: wet bulb temperature
Cooling Operation
Heating Operation
Domestic Hot Water
Cooling Operation
Heating Operation
Domestic Hot Water
-25WB
43DB
15 55

Table of Contents

Related product manuals