Operating the Engine
7
-2
① Range gear shift lever.
(L) Low Range
(H
)
High Range
(N) “Neutral” position
(R
) “
REVERSE”
3. Push the accelerator pedal down slowly.
① Speed control pedal
②=>
③ INCREASE
③=>② DECREASE
1.
Insert the key into the key switch and turn
it “START
”.
OFF
(Stop the Engine)
ON (Engine runs or headlights on)
START (Start the Engine)
IMPORTANT :
It is not sufficient to do daily checks on
dash board only. Always conduct dail
y
ch
ecks carefully by referring to “DAILY
CHECK“ in “PERIODIC SERVICE”
section.
5. Turn the key to “START” position and
release when the engine starts.
IMPORTANT:
Because of safety devices, the engine
will not start except when the gear shift
lever is placed in the “NEUTRAL”
position and the brake is depressed.
■
Cold Starting
When the ambient temperature is below -
15℃( 5℉), the engine is very cold. If the
engine fails to start after 5 seconds, turn off
the key for 30 seconds and start again
.
STOPPING THE ENGINE
1. After slowing the engine to idle, turn the
key to “OFF”.
2.
Remove the key.
WARMING UP
CAUTION:
To avoid personal injury:
Be sure to set the parking brake
during warm-up.
Be sure to set the shift lever to the