Hisun 750UTV - Replacing Radiator Hose (Water Pipes); Replacing Fuel Hose; Replacing Brake Master Cylinder; Replacing Front Brake Seal

Periodic Service
10-
18
of pressure within the cooling system.
5.
Adding the
LLC
1)
Add only water if the mixture reduces in
amount by evap
oration.
2
) If there is a mixture leak, add the LLC of
the same manufacturer and type in the
same mixture percentage.
*
Never add any long-life coolant of
different manufacturer.(Different brands
may have different additive components
,
and
the engine may fail to perform as
specified.)
6.
When the LLC is mixed, do not employ
any radiator cleaning agent. The
LLC
c
ontains anticorrosive agent. If mixed with
the cleaning agent, sludge may build up,
adversely affecting the engine parts.
7.
The vehicle’s genuine long-life coolant h
as
a
service life of 2 years. Be sure to
change the coolant every 2 years.
NOTE:
 The above data represent indus
try
s
tandards that necessitate a minimu
m
g
lycol content in the concentrated
antifree
ze.

When the coolant level drops due to
evaporation, add water only to keep the
antifreeze mixing ratio less than 50%. In
case of leakage, add antifreeze and
water
in t
he specified mixing ratio before f
illing
into
the radiator
.
■
Replacing Radiator Hose (Water pipes)
Replace the hoses and clamps
.
(See
“Checking Radiator Hose and Clamp” in
“EVERY 200 HOURS” in “PERIODIC
SERVICE” se
ction.)
■
Replacing Fuel Hose
C
onsult your local HUANSONG Dealer
for
This service.
■
Replacing Brake Master Cylinder (Inner
parts)
Consult your local dealer for this service.
■
Replacing Front Brake Seal
C
onsult your local dealer for this servic
e.
■
Replacing Rear Brake Cylinder Seal
Consult your local dealer for this servic
e.
■
Replacing Intake Air Line
Consult your local dealer for this servic
e.
EVERY 4 YEARS
■ Replacing Brake Hose
C
onsult your local Dealer for this servic
e.
■
Replacing Mini Fuses
Th
e Mini fuses are intended to protect the
electrical cabling. If any of them have
blown
o
ut, be sure to pinpoint the caus
e.
◆ Replacing procedure
1
) Disconnect the negative cable of the
battery.
2) Open the Mini fuse box cover
.
3
) Pull out the Mini fuse.
4) Insert a new Mini fuse into the box.
5
) Close the Mini fuse box cover.
6) Connect the negative battery cable.