Periodic Service
10
-8
① Torque wheel bolts to 75to 90 N.m
■
Cleaning air cleaner primary element
1. Remove the air cleaner cover and
primary element.
2.
Remove the sponge material from its
frame.
3.
Wash the sponge material gently but
thoroughly in solven
t.
4.
Squeeze the excess solvent out of
the
s
ponge material and let it dry.
5.
Inspect the sponge material and replace
it if damaged.
6.
Thoroughly apply foam air filter oil
or
o
ther quality liquid foam air filter oil (n
ot
s
pray type) to the sponge mate
rial.
7.
Re-install the air filter element.
8. Install the air filter case cover and
be
sure the crankcase breather hose is
connected.
① Air filter element
① Air filter element
② Locating pad
①
Holder(×6) ② Air filter case cover
IMPORTANT
The air cleaner uses a dry element never
apply oil.
Do not run the engine with filter element
remov
ed.
Be sure to refit the cower with the arrow (on
the rear of cower ) upright if the cover is
improperly fitted the evacuator valve will
not
f
unction and dust will adhere to the element.
◆
Evacuator Valve
Open the air cleaner cover once a week u
nder
o
rdinary conditions –or daily when used in a
dusty place-to get rid of large particles of dust
and
dirt.
C
heck fuel line and fuel filter.
To Next Page
Loading...
