Periodic Service
10-
13
oil can be hot and can burn.
1.
Park the vehicle on a flat surface, r
aise
the
cargo bed, and mount the
safety
support.
2. Put a film of clean transmission
oil;
3.
Quickly tighten the filter until it contacts
the mounting surface, tighten it an
a
dditional 1 turn only
.
4
. After running the engine for a fe
w
minutes, stop the engine and check the
oil level again. Add oil to the prescribed
level.
Oil capacity [Filter exchanged] 1L (1.05U.S. qts.)
① Oil Lever
② Dipstick
■ Checking Brake Pedal
CAUTION
Stop the engine and chock the wheels
b
efore checking brake p
edal.
If movement is outside of th
e
specifications contact your local dealer
for adjusting the brake
.
◆ Checking the brake pedal free travel
Proper brake pedal
free travel
7 to 14mm
(0.3 to in.)On the pedal
1
. Release the parking brake.
2. Slightly depress the brake pedal and
measure free travel at the top of the pedal
strok
e.
3. If brake pedal free travel is outside of the
specifications, contact your local dealer for
adjusting the brak
e.
◆ Checking the brake pedal stroke
Pedal stroke
Less than 120mm (4.7in.)
On the pedal
1. Release the parking brake.
2
. Step on the pedal and measure the peda
l
stroke.
3. If brake pedal stroke is outside of the
specifications, contact your local dealer for
adjusting the brak
e.
① Brake pedal
②
“
FREE TRAVEL” ③ “PEDAL STROKE”
■ Checking Brake Hose and Pipe
1. Check to see that brake hose and lines are
not swollen, hardened or crac
ked.
2. Check the brake hose and pipe joints for oil
leaks
.
3
. If there is any abnormality, consult your loca
l
dealer for this service.
■
Checking Brake Light Switch
1.
Park the vehicle on a flat surface and rais
e
t
he cargo bed
.
2
. Turn the key switch to the “ON” pos
ition.
Step on the brake pedal to check if the brake
To Next Page
Loading...
