Hisun 750UTV - Checking Engine Start System; Checking Wheel Bolt Torque

Periodic Service
10
-7
① Range gear shift lever pivot (spray type grease )
■
Checking engine start system
CAUTION
TO avoid personal injury
 Do not allow anyone near the vehicle
while testin
g.
 If the vehicle does not pass the test,
do not operate the veh
icle.
◆
Preparation before testing
1.
Place all control levers in the
“NEUTRAL” position.
2. Set the parking brake and stop the
e
ngine.
◆
Test gear shift range lever safety
sw
itch
1
. Sit on the operator’s seat.
2.
Shift the range gear shift lever to: “L”,
“H”, “N” or REVERSE position.
3. Turn the key to “START” pos
ition.
4.
The engine must not crank.
5. If it cranks consult your local dealer for
t
h
is service.
Bench seat
① Range gear shift lever
Bucket seat
① Range gear shift lever
■
Checking wheel bolt torque
CAUTION
To avoid personal injury
 Never operate vehicle with a loose whe
el
bolts.
 Any
time these bolts are loosened th
ey
shoul
d be retightened to the specified
torque.
 Check
all bolts frequently and keep them
tight.
C
heck wheel bolts regularly especially when new
if they are loose tighten them as follows: