Hisun HS 200UTV-2 - Page 37

Introduction HS 200UTV-2/HS 250UTV-2
1-37
IMPORTANT
 If the radiator cap has to be removed,
follow the cautions above and securely
retighten the cap.
 Use clean fresh water and anti-freeze to
fill the recovery tank.
 If water should leak, consult your local
Hisun Dealer.
■ Cleaning radiator screen
CAUTION
TO avoid personal injury:
 Be sure to stop the engine before
removing the screen
1. Park the vehicle on a flat surface,
2. Remove the radiator cover,
3. Detach the screen and remove all foreign
materials.
① Radiator screen
IMPORTANT
 Radiator screen must be cleaned from
debris to prevent engine from overheating
■ Checking brake fluid level
CAUTION
TO avoid personal injury:
 Never operate the vehicle if the brake
fluid is below the minimum mark.
 Use only DOT3 from a sealed
container. Other types of brake fluid
may ruin synthetic resin or rubber
installed in brake system components
and may cause brake failure.
 Avoid contamination of the brake fluid
thoroughly clean before removing the
filler cap. Do not open the brake fluid
reservoir cap unless absolutely
necessary.
Use extreme care when filling the reservoir.
If brake fluid spills on the power steering
hose, wash it off with water immediately, as
brake fluid quickly ruins synthetic resin or
rubber hoses.
1. Park the vehicle on a level ground and
open the hood.
2. Check to see that the brake fluid level is
up to the MIN mark.
3. If it is below the “MIN” mark add brake
fluid .
① MAX ② MIN