Hitachi CB 520H A1 User Manual

LP communication settings
Specify the port number to be used for communication between LPAR
manager and management module.
All LPAR managers in the server chassis use the same port number. You
cannot use a different port number for an individual LPAR manager.
Before you change the setting, make sure that all server blades for which
Logical partitioning is set to Enable.
Firmware combinations
Server blade
Server blade
firmware
Management Module
firmware
LPAR manager
firmware
CB 520H B3 08-35 or later A0260 or later 02-25 or later
CB 520H B4 10-03 or later A0305 or later 02-50 or later
CB 520X B1 07-34 or later A0260 or later 02-25 or later
CB 520X B2 09-17 or later A0270 or later 02-27 or later
CB 520X B3 11-07 or later A0320 or later 02-56 or later
Note:
• To set port numbers, the firmware combination of all the server blades
whose Logical Partitioning is set to Enabled must be a combination that
supports this function. If the firmware combination does not support this
function, port numbers cannot be set.
Specifying LP communication settings
To specify LP communication settings, perform the operations described
below from the Web console.
Item Operation
LP communication settings Resources tab > Systems > LP
communication settings
DNS
LPAR manager supports name resolution by using a DNS. You can specify
some servers that link to LPAR manager by using host names.
Supported version
Item Version
Management Module firmware A0280 or later
2-20
System Operation
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide

Hitachi CB 520H A1 Specifications

General

Brand	Hitachi
Model	CB 520H A1
Category	Server
Language	English