Hitachi CB 520H A1 User Manual

LPAR manager Setting Items
The following table shows LPAR manager setting items required to configure
LPAR manager.
Table B-1 LPAR manager setting items
item Setting items Description default
Support
Version
Web Console LPAR manager firmware
Bank
Sets 0 to 3 0 01-0X or
later
Logical Partitioning Sets the LP mode Depends on
a factory-
shipments
state
01-0X or
later
IPv4 LP IP
Address
Set the LP IP address for IPv4 and
other items.
0.0.0.0 01-0X or
later
Subnet Mask 0.0.0.0 01-0X or
later
Default
Gateway
0.0.0.0 01-0X or
later
IPv6 Static
address
Set the LP IP address for IPv6 and
other items.
Disabled 02-25 or
later
IP address - 02-25 or
later
Prefix len - 02-25 or
later
Default
gateway
Not used 02-25 or
later
Address - 02-25 or
later
Stateless
address
Disabled 02-25 or
later
LP communication settings Sets the protocol that is used for
communication between LPAR
manager and the management
module.
IPv4 02-25 or
later
VNIC System No Sets VNIC System No
*Sets the value which does not
overlap with all LPAR manager(s)
which is containing Compute
Blade Series.
0 01-0X or
later
Time Zone Sets LPAR manager System time
zone
Depends on
a factory-
shipments
state
01-0X or
later
Performance tuning options To enable Performance tuning
options, set Enable.
Disabled 02-27 or
later
B-2
Setting Item List
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide

Hitachi CB 520H A1 Specifications

General

Brand	Hitachi
Model	CB 520H A1
Category	Server
Language	English