In this example, 78 is a driver handle.
11. Enter drvcfg driver handle, then Search the controller handle.
In this example, 84 is controller handle.
Tip:
• Multiple results are displayed when multiple FC ports are allocated to
LPAR. Any displayed controller handle can be selected.
12. Enter drvcfg –s driver handle controller handle then hfccfg >
prompt is shown.
13. Enter select command then select FC adapter which is using for a
booting.
In this example, select 1.
14. Enter Set command, and then Set items are as follows. Set the other
items according to your environment, if required.
Note that you do not need to set LUID scan mode if LUID scan mode is
not displayed.
– Boot Function = Enabled
– Select Boot Device = Enabled
– LUID scan mode = Disabled (The LUID inheritance method is not
supported.)
– Set the WWPN and LUN No. of port which are used on the target
external disk array equipment to the Boot Device List, Usually List.
Usually LU0 is considered as the boot LU, therefore setup 0.
5-38
Setup of LPAR manager
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
