4. Select the boot device to create boot option.
Tip:
• Check the disk array configuration to make sure the configuration is
correct if HBA device is not recognized.
• For a logical BIOS boot, "*" appears at the end of the message of the
boot device that OS has been installed.
• For a logical EFI boot, select NO VOLUME LABEL or SYSTEM as the
boot device to create boot option.
Note that the displayed information might vary depending on the boot
medium.
The example of NO VOLUME LABEL following:
Setup of LPAR manager
5-49
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
