Table 7-5 Details of the LPAR Configuration Screen
No. Item Description
Default
Value
Supported
LPAR
manager
Version
(1) # Displays the LPAR numbers. - 01-0X~
(2) Name Sets the LPAR name.
Maximum character length of LPAR
name is 31. And identical LPAR name
cannot set to 2 or more files.
The 8th character is changed to tilde '~'
and the later characters are omitted
when the length of LPAR name is 9 or
more.
'0' ~ '9', 'A' ~ 'Z', 'a' ~ 'z', '-'and '_' can
be used for LPAR name. However only
'A' ~ 'Z' and 'a' ~ 'z' can be used for the
initial character.
NO_NAME 01-0X~
(3) Sta Displays the LPAR status.
Act (Activate): The LPAR is powered on.
Dea (Deactivate): The LPAR is powered
off.
Fai (Failure): The LPAR cannot be used
due to an unrecoverable failure. Reboot
LPAR manager when this happens.
Activate, deactivate and reactivate the
LPAR.
Dea 01-0X~
(4) Scd Sets a scheduling mode.
S: Shared mode
D: Dedicated mode
D 01-0X~
(5) Pro Sets the number of logical processors to
allocate to the LPAR.
- 01-0X~
(6) Grp Sets the processor group number. D 01-0X~
(7) Srv
(Service
Ratio)
Set a value between 1 and 999 as the
relative allocation (service ratio) of the
time an LPAR uses a physical processor
(Service-time).
This value is only meaningful for shared
mode LPARs. It is meaningless for
dedicated mode LPARs and cannot be
set for them.
100 01-0X~
(8) Mem Sets the memory size allocated to an
LPAR in units of MB. This is always a
multiple of 256.
1024 01-0X~
(9) VN
(Virtual
Network
Displays the number of Logical NICs
allocated to the LPAR.
0 01-0X~
Operation by LPAR manager Screen
7-11
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
