Hitachi CB 520H A1 - Page 318

No. Item Description
Default
Value
Supported
LPAR
manager
Version
Error: The path is in a network failure
state.
Link down: The path is in a link-down
state, or the management path is in a
blocked state.
Unknown: LPAR manager is unable to
communicate externally.
-----: No port is specified for the path.
This item is displayed if firmware
combination supports changing
management path specification.
For the firmware combination details, see
"
Firmware combinations".
(11) TYPE Shows the type of the PCI device in the
shared scheduling mode on the PCI Device
Assignment screen.
N: Network interface Card (NIC)
Add "v" to the end of line when using VF
NIC.
F: Fibre Channel
- 01-0X~
(12) NIC# Displays the shared NIC number (1 ~ 6)
when the device type is No shown in (7).
Displays "-" when the device type is F in
(7).
- 01-0X~
(13) PORT# Displays the port number (0 ~ 3). - 01-0X~
(14) SLOT# Displays the slot number. - 01-0X~
(15) Shared PCI
Device Port
State
Displays the status of the PCI device in the
shared scheduling mode on the PCI Device
Assignment screen.
When Device Type is N shown in (7):
U: Link Up status
D: Link Down status
E: The device cannot be used due to an
unrecoverable error.
-: The status is unknown.
Blank: Shared NIC is not defined.
When Device Type is F shown in (7):
A: Available. The device is in the normal
status and usable.
D: LinkDown. The device cannot be used
because no cable is connected to it.
C: ConfigCheck. The device cannot be used
because of a configuration problem.
D 01-0X~
7-80
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide