Message Content LP changed Management Path.
Explanation The management NIC was changed.
What to do None.
Message Content LP changed NIC to dedicated mode.
Explanation A NIC exists for which the mode was changed into the dedicated
mode because the number of shared NICs exceeded the
maximum by changing the scheduling mode of the NIC specified
as the management NIC to the shared mode.
What to do None.
Message Content LP completed deletion of the initial parameter file.
Explanation The initial parameter file was completely deleted.
What to do None.
Message Content
LP detected a network communication recovery on the
active port.
Explanation A communication failure in the active path was corrected on the
LPAR manager management NIC.
What to do None.
Message Content
LP detected a network communication recovery on the
standby port.
Explanation A communication failure in the standby path was corrected on the
LPAR manager management NIC.
What to do None.
Message Content LP detected Driver request MCK for Shared FC.
Explanation The failure recovery request from the guest OS has been
accepted in the shared FC.
What to do None.
Message Content LP detected failed SR-IOV feature was recovered.
Explanation LPAR manager detected that the isolated PCI device recovered.
What to do PCI device recovered.
Start the guest OS, then the PCI device can be used again.
9-48
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
Need help?
General