ID Message
Operation for which an audit log is
collected
NUMA node number, for an LPAR and the
request fails"
01003202
"Set the maximum aggregate throughput
(Mbps) value of VF NIC. LPARxxx
VNIC#:xxx Value:xxx"
When HvmSh and so on is used to request
change of the transmission band restriction
for an VF NIC (TXRATE) and the request
immediately succeeds
01003204
"Set the maximum aggregate throughput
(Mbps) value of VF NIC. LPARxxx
VNIC#:xxx Value:xxx"
When the LPAR manager screen is used to
request change of the transmission band
restriction for an VF NIC (TXRATE) and the
request succeeds
01003205
"Failed to set the maximum aggregate
throughput (Mbps) value of VF NIC.
LPARxxx VNIC#:xxx Value:xxx"
When the LPAR manager screen is used to
request change of the transmission band
restriction for an VF NIC (TXRATE) and the
request fails
01003206
"Set the guest NUMA for the LPAR.
LPARxxx Value:xxx"
When HvmSh and so on is used to request
change of the guest NUMA setting and the
request immediately succeeds
01003208
"Set the guest NUMA for the LPAR.
LPARxxx Value:xxx"
When the LPAR manager screen is used to
request change of the guest NUMA setting
and the request succeeds
01003209
"Failed to set the guest NUMA for the
LPAR. LPARxxx Value:xxx"
When the LPAR manager screen is used to
request change of the guest NUMA setting
and the request fails
0100320A
"Set the memory capacity allocated to
the specified LPAR for each NUMA node
number. LPARxxx Node#:xxx Value:xxx"
When HvmSh and so on is used to request
change of memory size for an LPAR with its
guest NUMA enabled and the request
immediately succeeds
0100320C
"Set the memory capacity allocated to
the specified LPAR for each NUMA node
number. LPARxxx Node#:xxx Value:xxx"
When the LPAR manager screen is used to
request change of memory size for an LPAR
with its guest NUMA enabled and the request
succeeds
0100320D
"Failed to set the memory capacity
allocated to the specified LPAR for
each NUMA node number. LPARxxx
Node#:xxx Value:xxx"
When the LPAR manager screen is used to
request change of memory size for an LPAR
with its guest NUMA enabled and the request
fails
0100320E
"Set the guest idle mode for the LPAR.
LPARxxx Value:xxx"
When HvmSh and so on is used to request
change of the GuestIdleMode setting for an
LPAR and the request immediately succeeds
01003210
"Set the Low Latency option for the
LPAR. LPARxxx Value:xxx"
When HvmSh and so on is used to request
change of the LowLatency setting for an LPAR
and the request immediately succeeds
01003212
"Set the EPT1GB option for the LPAR.
LPARxxx Value:xxx"
When HvmSh and so on is used to request
change of the EPT1GB setting for an LPAR
and the request immediately succeeds
01003214
"Set the PRTE option for the LPAR.
LPARxxx Value:xxx"
When HvmSh and so on is used to request
change of the PRTE setting for an LPAR and
the request immediately succeeds
9-84
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
