102
9. Troubleshooting
Phenomenon: Cannot communicate with the projector. (Wireless network)
Item to be checked Solutions
Is the projector turned on? Turn on the projector.
Is the network device such as an
access point, etc. turned on?
Turn on the network device.
Is STANDBY MODE set to
SAVING?
The network function is not available when
STANDBY MODE is set to SAVING. If you
want to use the network function in the standby
mode, set to NORMAL.
Are the network settings such as
IP address set correctly?
Check the network settings in the NETWORK
INFORMATION
䠉
WIRELESS menu. Consult
with your network administrator for details.
Is the USB wireless adapter
(optional parts: USB-WL-11N)
inserted into WIRELESS port of
the projector?
Insert the USB wireless adapter.
Is an optional USB wireless
adapter used?
The USB wireless adapter available to this
projector is optional USB-WL-11N only.
Is MAC address displayed
correctly in the NETWORK
INFORMATION
䠉
WIRELESS
menu?
When MAC address displayed in NETWORK
INFORMATION – WIRELESS menu does not
match MAC address engraved on the USB
wireless adapter, pull out and insert the USB
wireless adapter again.
If the problem persists, the USB wireless
adapter may be broken. Contact your dealer.
Is LED of the USB wireless
adapter blinking?
When LED of the USB wireless adapter does
not blink in over 1 minute after inserting, pull
out and insert the USB wireless adapter again.
If the problem persists, the USB wireless
adapter may be broken. Contact your dealer.
To Next Page
Loading...
