16
2.4.2 Connection in Infrastructure Mode
Set the following when connecting the projector and the computer in Infrastructure
mode.
[Restriction on plugging and unplugging the USB wireless adapter]
Before you insert or pull out the USB wireless adapter from the projector, turn off
the power of the projector and pull out the power cord’s plug from the outlet. Do
not touch the USB wireless adapter that is connected to the projector while the
projector is receiving AC power.
Do not use any extension cable or device when connecting the adapter to the
projector.
1) Attach the USB wireless adapter to the WIRELESS port of the projector.
2) Turn on the projector.
3) Press the MENU button on the remote control or the
control panel of the projector.
The MENU you last used will appear.
Use the cursor button to select the following.
EASY MENU > ADVANCED MENU > NETWORK > WIRELESS SETUP
4) Set the following items in WIRELESS SETUP.
䡡㻌MODE: INFRASTRUCTURE
䡡㻌㻌DHCP
䡡㻌IP ADDRESS
䡡㻌SUBNET MASK
䡡㻌DEFAULT GATEWAY
䡡㻌DNS SERVER
䡡㻌SSID
䡡㻌ENCRYPTION
䡡㻌CH
As for setting an IP address, refer to “About IP address”. (
13)
Select APPLY, then press the ENTER button to reflect the settings.
2. Connection to the network
To Next Page
Loading...
