Hitachi CP-X9110 Network Guide

90
8. Other Functions
8.2 Projector Management using SNMP
The SNMP (Simple Network Management Protocol) enables to manage the
projector information, which is a failure or warning status, from the computer on
the network.
• It is recommended that SNMP functions are executed by a network
administrator.
• SNMP management software must be installed on the computer to monitor
the projector via SNMP.
NOTE
Standard MIB (MIB-2)
You can refer the following items defined in system group of Standard MIB (MIB-2).
Item Description
sysName Projector name is set.
sysLocation The information on where it is located. It has character string
set in sysLocation (SNMP) in Projector Web Control - [Network
Settings] - [Common Setup].
sysContact The information on the administrator's contact information. It
has character string set in sysContact (SNMP) in Projector
Web Control - [Network Settings] - [Common Setup].
Enhanced MIB
You can get configuration information by using Enhanced MIB for projectors.
Enhanced MIB for projectors can be downloaded from [Port Settings] page in
Projector Web Control.
Trap
When an error or warning occurs in the projector, a notification can be sent to the
specified address.
In addition to e-mail alert shown in 8.1 Email Alerts (
87), the following
notification can be sent.
Item Description
Cold Start When the projector is supplied with the power, it works as
below.
• If the STANDBY MODE is set to the NORMAL: the projector's
power status changes from “OFF” to “Standby state”.
• If the STANDBY MODE is set to the SAVING: the projector's
power status changes from “Standby state” to “ON (lamp is
turned on)”.
(

SETUP menu in the Operating Guide).
Authentication Failure The SNMP access is detected from the invalid SNMP
community.

Hitachi CP-X9110 Specifications

General

Brand	Hitachi
Model	CP-X9110
Category	Projector
Language	English