12
2. Connection to the network
2.2
㻯㼛㼚㼚㼑㼏㼠㼕㼛㼚㻌㼢㼕㼍㻌㼣㼕㼞㼑㼐㻌㻸㻭㻺
The connection via wired LAN is available. Set wired LAN for the projector by
following the instructions of your network administrator when connecting to the
existing network.
1) Connect the projector to the computer via a hub
with a LAN cable (CAT-5e or higher).
2) Press the MENU button on the remote control or the
control panel of the projector.
The MENU you last used will appear.
Use the cursor button to select the following.
EASY MENU > ADVANCED MENU > NETWORK > WIRED SETUP
3) Set the following items in WIRED SETUP.
䡡㻌㻌DHCP
䡡㻌IP ADDRESS
䡡㻌SUBNET MASK
䡡㻌DEFAULT GATEWAY
䡡㻌DNS SERVER
As for setting an IP address, refer to “About IP address”. (
13)
Select APPLY, then press the ENTER button to reflect the settings.
2.3 Connection setup of Wired LAN
hub
To Next Page
Loading...
Need help?
General
