108
9. Troubleshooting
Phenomenon:
Cannot control the external device by using Network Bridge.
Item to be checked Solutions
Is Network Bridge settings
enabled?
Check the settings in OPTION – SERVICE
– COMMUNICATION – COMMUNICATION
TYPE menu.
Is STANDBY MODE set to
SAVING?
The Network Bridge is not available when
STANDBY MODE is set to SAVING. Set
STANDBY MODE to NORMAL, and set
NETWORK BRIDGE (WIRELESS/WIRED) in
the COMMUNICATION TYPE menu.
Are the serial settings set
correctly?
Check the serial settings of the projector and
the external device.
To Next Page
Loading...
