Hitachi HA820 G2 - Page 14

Hitachi Advanced Server HA820 G2 User Guide 14
Item Description Status
◦ 1 Hz/cycle per sec = Remote management or firmware
upgrade in progress
◦ 4 Hz/cycle per sec = iLO manual reboot sequence
initiated
◦ 8 Hz/cycle per sec = iLO manual reboot sequence in
progress
◦ Off = Deactivated
2 NIC status LED
1
• Solid green = Link to network
• Flashing green (1 Hz/cycle per sec) = Network active
• Off = No network activity
3 Health LED
1
• Solid green = Normal
• Flashing green (1 Hz/cycle per sec) = iLO is rebooting
• Flashing amber = System degraded
• Flashing red (1 Hz/cycle per sec) = System critical2
4 Power On/Standby
button and system
power LED
1
• Solid green = System on
• Flashing green (1 Hz/cycle per sec) = Performing power on
sequence
• Solid amber = System in standby
• Off = No power present3
1
When all four LEDs described in this table flash simultaneously, a power fault has occurred.
2
If the health LED indicates a degraded or critical state, review the system or use iLO to review
the system health status.
3
Facility power is not present, the power cord is not attached, no power supplies are installed,
power supply failure has occurred, or the power button cable is disconnected.
12 LFF front panel LEDs and buttons