Hitachi IJ RX2 - Change of Buttons, Icons and Status Colors

9-7 ●Change of Buttons, Icons and Status Colors
Standby/Ready Change Button
State
Standby/Ready Change Button
Disable Enable
Standby [standby ] [ ]
Ready [Ready ] [ ]
2015.07.07 12:45
M
Manual
Message name[SAMPLE1  ]
[ ]
Shutdown
Print description
《 》
Current user ID：adminNo. 1
Com=0
Ready
2015.07.07 12:45
M
Manual
Message name[SAMPLE1
 
]
[ ]
Shutdown
Print description
《 》
Current user ID
：
adminNo. 1
Com=0
Standby
Standby
Ready
Change of Buttons, Icons and Status Colors
(1) “Standby/Ready Change Button”
● When the Control Menu Buttons are available on the touch screen, “Standby/Ready Change Button” will be
displayed ([Disable] and [Enable]).
● When this button is used (i.e., Enabled), the number of button pressing can be reduced by one (1).
When you would like to make changes on the buttons, icons and status colors,
please contact your nearest local distributor.
Standby state (with button)
Ready state (with button)
Number of vertical dots used in the nozzle diameter is 65μm.
Ink drop use rate
1/1 1/2
HM NM QM -
1-line print
Character size 12
×16
16 24 - 32
2-line print
Character size 5
×5
10 15 - 20
Character size 5
×7
14 21 - 28
Character size 5
×8
16 24 - 32
Character size 7
×10
20 30 - 40
3-line print
Character size 5
×5
15 20 25 30
Character size 5
×7
21 28 35 42
Character size 5
×8
24 32 40 48
Type of high-speed print and number of vertical dots used
● Number of vertical dots used in high-speed print is shown in Table below.
● When calculating printing preparation time, etc., pay attention to number of vertical dots.
2