6.9 Replacing the circulation filter
● Perform it a state in which the ink has been drained. The ink is not wasted if performed simultaneously with
the ink replacement.
Perform -(a) to -(c) of the procedure in “6.3 Replacing the ink”.
● Perform from ink drainage to place the ink reservoir tube connection block back into position.
● Perform operation in accordance with the operation guide on the screen.
1
22
Replace the circulation filter. See “6.8 Replacing the recovery filter” for the
replacement procedure.
2
Perform -(a) to -(i) of the procedure in “6.3 Replacing the ink”.
● Refill the IJ Printer with ink.
3
33
Open the Part usage time mgmt. screen (menu 2 of the Circulation control
screen) and set the time of the circulation filter to “0”.
4
Circulation filter
To Next Page
Loading...
