6-31 ●Draining ink from the main ink tank
6.13 Draining ink from the main ink tank
● When the main ink tank full fault is generated, the ink cannot be drained by screen operation. Drain the ink
and refill with new ink as follows:
Remove the drain tube of the main ink tank as shown in the figure below and
drain the ink in the tank by approximately 50 ml. When ink is drained, put the
drain tube block to its original position.
1
Return the circulation system to its original state and display the Circulation
control screen and press the Ink refill → Start/Continue .
*Note that if operation is started without refilling the ink, a “Replenishment Time-out”
fault will be generated.
2
● If the ink is accidentally spilled, quickly wipe if off with wiping paper, etc.
In addition, do not close the maintenance cover until you confirm that the wiped part
is completely dry.
CAUTION
Drain tube
Beaker
Main ink tank
Drain tube Stop plug
Clean the tip of Drain tube by Makeup after
using IJ printer. If the tip of Drain tube was left
without cleaning, Drain tube would be clogged
and it might be difficult to get the ink drained.
To Next Page
Loading...
Need help?
General
