Hitachi IJ RX2 - Replacing the Ink Filter

6-17 ●Replacing the ink filter
Circulation control
Select option; press [Start/Cont.] Proc. status:
2015.07.0712:45
Com=0
[Stop ]
Eject ink
(Goes to Standby)
Cleaning stop No-cleaning stop
Nozzle backwash
Recovery-line
cleaning
Ink replacement
Ink filter
replacement
Ink circulation
Cancel
Start/Continue
HOME
Prev.Dsp.
NextDsp.
Process prior to
long-term shutdown
Process after
long-term shutdown
Makeup refill
6.7 Replacing the ink filter
Perform it in a state in which the ink has been drained. The ink is not wasted if performed
simultaneously with the ink replacement.
2
Display the Circulation control screen and press the Ink filter replacement →
Start/Continue .
1
Follow the operation guidance on the screen and drain the ink from the ink
filter and ink circulation system.
● Press Abort to cancel ink draining.
● When Abort is selected, go back to setup above and continue.
If ink is accidentally spilt, wipe it up promptly with wiping paper or equivalent.
In addition, do not close the maintenance cover until you are sure that the wiped area
is completely dried.
CAUTION
2
1
(a) Change the direction of the ink filter so that tubes become the bottom,
disconnect the recovery block from the main ink tank and put it in a beaker.
Ink replacement
Start/Continue
Recovery tube
Ink filter tubes
Ink filter