●Input/output (I/O) signal connection 4-6
Pin
No.
Name Input/output
Remarks
NPN Interface PNP Interface NPN PNP
1 Power supply for Print target detector Output
● DC24V, 100mA max. (*1)
● Power supply, NPN / PNP can be selected
by SW1.
2 Print target detector Input
3 Ground for Print target detector -
4 Print stop Input
● NPN / PNP can be selected by SW2
● RX2-S: Standard, RX2-B: Option
5 Signal ground -
6 Power supply for encoder Output
● DC24V, 100mA max. (*1)
● Totem pole / Open collector (NPN) can
be selected by SW1
● Power supply can be selected by SW1
7 Encoder signal (Totem pole) Input
8 Encoder signal (Open collector NPN) Input
9 Ground for Encoder -
10 Ready - Output -
● Open collector (NPNn) only.
11 Signal ground - - -
12 Fault - Output -
13 Warning - Output -
14 Deflection voltage ON/OFF signal Input
● NPN / PNP can be selected by SW2
● RX2-S: Standard, RX2-B: Option
15 Reciprocative print signal Input
16 Run signal Input
17 Reset signal Input
18 Stop signal Input
19 Print-in-progress / Print-complete Output
● Print-in-progress/ Print-complete can be
selected with screen operation.
● NPN / PNP can be selected by SW2
● RX2-S: Standard, RX2-B: Option
20 Online output Output
21 Universal output 1 Output
22 Universal output 2 Output
23 Signal ground -
[ Connection to the external connection terminal block (TB1 of EZJ127 P.W.B) ]
(*1): The supplying power capacity for print target detector and encoder is up to 100mA in total.
● The I/F signal with conveyer is connected.
● NPN/PNP interface can be selected for the print target detector and a part of I/O signals.
● Totem pole/Open collector(NPN) can be selected for the encoder signal.
● Pin #4, #5 and #14 to 23 --- RX2-S:Standard, RX2-B: Option
To Next Page
Loading...
