Hitachi SJ700-4000HFU2

Chapter 5 Error Codes
5-10
5.2 Warning Codes
The following table lists the warning codes and the contents of parameter readjustments:
Warning code
Target function code
Condition
Basic function code
001/
201
Frequency upper limit setting (A061/A261)
>
Maximum frequency setting
(A004/A204/A304)
002/
202
Frequency lower limit setting (A062/A262)
>
005/
205/
305
Output frequency setting (F001) (*)
>
015/
215
Output frequency setting (F001) (*)
>
Frequency upper limit setting
(A061/A261)
019
Home search speed setting (P015)
>
025/
225
Output frequency setting (F001) (*)
<
Frequency lower limit setting
(A062/A262)
029
Home search speed setting (P015)
<
031/
231
Frequency upper limit setting (A061/A261)
<
Start frequency adjustment (b082)
032/
232
Frequency lower limit setting (A062/A262)
<
035/
235/
335
Output frequency setting (F001) (*)
<
037
Jog frequency setting (A038)
<
085/
285/
385
Output frequency setting (F001) (*)
< >
Jump (center) frequency settings 1/2/3
± " Jump (hysteresis) frequency width
settings 1/2/3"
A063 ± A064, A065 ± A066,
A067 ± A068
086
Multispeed 1 to 15 settings (A021 to A035)
< >
091/
291
Frequency upper limit setting (A061/A261)
＞
Free-setting V/f frequency (7) (b112)
092/
292
Frequency lower limit setting (A062/A262)
＞
095/
295
Output frequency setting (F001) (*)
＞
- The inverter displays a warning code when the data set as a target function code satisfies the condition (specified in the
Condition column) in relation to the data set as the corresponding basic function code.
- When the inverter is warning, it can not run to work the motor. Refer to the above column and modify the patramerters to the
correct data.
- When the inverter is warning, you can confirm the warning information ‘d090’.
* These parameters are checked, even when the digital operator (02) is not specified for the frequency source setting (A001).