Hitachi SJ700-4000HFU2

Chapter 3 Operation
3-20
3.5.3 Run command source selection
Key operation to set A002
****FF3 : Change from 02 (operator) to 01 (control circuit terminal block).
Procedure
Key operation
Indication
Details
2-1
.
After powering up of the inverter, the operator displays
0.00, output frequency monitor (d001)
2-2

Indication changes from data (0.00) to parameter (d001).
2-3
or

Push the key and select the head of Group A.
2-4

Push the key and indication changes to A001.
2-5

Push the key and select A002 (Run command source).
2-6

Push the key and indication changes to 02(operator).
2-7

Push the key and change the data to 01 (control circuit
terminal block).
2-8

Push the key and indication changes to A002 (Data save).
2-9
.
By pushing the key for more than three seconds,
indication changes to the output frequency data.
****FEF3/FUF3 : Change 01 (control circuit terminal block) to 02 (operator).
*) Replace the procedure 2-6 and 2-7 on the list above with 2-6’ and 2-7’ in the list below.
Procedure
Key operation
Indication
Details
2-6’

Push the key and indication changes to 01 (control circuit
terminal block).
2-7’

Push the key and change to 02(operator).
FUNC
STR
1
2
FUNC
FUNC
FUNC
FUNC
1
2
1