Hitachi SJ700-4000HFU2

Chapter 3 Operation
3-13
3.4 Example of I/O connections
Example 1: Frequency command source Setting data in F001 (Digital Operator)
Run command source RUN/STOP key (Digital Operator)
*) SJ700D-****FF3 (Initial settings)
(1) I/O connections
(2) Operation
Frequency: By using the digital operator, set the frequency command into parameter F001.
Run/Stop: Push the key and on the digital operator to run and stop.
*) Refer to 3.5.2 for changing the frequency command source and 3.5.3 for changing the run
command source.
(3) Parameter settings
Parameter
Details
Setting data
A001
Digital Operator

A002
Digital Operator

F001
Output frequency setting
. Note)
Note) Initial settings are 0.00Hz. You need to set the appropriate data.
ELB
V
R/L1
S/L2
T/L3
R
T
R0
T0
P
PD
N
RB
U
V
W
M
3-phase induction motor
RUN
STOP/
RESET